MCM (online Motor Condition Monitor) software and hardware-based product by Artesis that has been developed using model-based monitoring technology and is being effectively used for process monitoring, predictive and proactive maintenance activities in different sectors of the industry.

It is a device that continuously monitors electric motor-based machinery and equipments (fans, compressors, pumps, press machines, conveyors) used in several processes in a plant and has the ability of detecting impending mechanical and electrical failures (imbalance, misalignment, bearing and rotor faults, leakages, valve and vane maladjustments, isolation and other electrical problems) in these systems at the early stages of fault development using only voltage and current measurements. It can pinpoint several anomalies in an equipment, plant or process that might initiate failure generation.

DEI_MCM_BROCHURE.pdf (638 Kb, 12 downloads)

Why the first M in MCM stands for MOTOR, not Machinery because it can monitor so many machineries? Or do you means it can only monitor motors driving the other mentioned machineries? How does it fit into existing SCADA installed?

Josh

MCM monitors motor parameters and infers degradation in the driven equipment from the motor response.

Correction:
MCM can be integrated in any automation or SCADA system through Mobdus protocol.

This message has been edited. Last edited by: Steven Shores,