Please help

What setup parameters do I need in Entek Odyssey to record motor current readings?

measurement definition setup:
data type, units, collection and filter.

transducer calibration:
input type, units, calibration value for a 1mv per amp current transformer and dc offset.

Thanks for any help.

I have my point set up with amplitude, spectrum and waveform. Units = V (Volts). My probe puts out voltage from the amp meter.I created a couple new Collection specs that have transducer =voltage, hanning window, RMS, 1avg, linear, 6000 cpm fmax (to zoom in 60hz) and 3200 lines. It is a long reading but resolution is critical. I also take one at 36000 cpm to look for any mechanical indications. I use the overall filter.The voltage settings in the Calibration menu say input type defined and V,1,0. There can be no power sent out to the amp probe.

You need a template use SPECTRUM/AMPS.

Wayne

WAX.doc (230 Kb, 31 downloads) Datapac Amps

hi all

please who has a procedure likes the attached by Mr wayane for tri-axial transducer set up?

do yoy have wayne A?

thank you

It is highly unlikely you can do similtaneous tri axial readings.

Emonitor 2.2 + can be configured using groups (similar to tagging) however unless you are using an online monitoring system I suggest collecting 3 individual readings.

Suggest using simple accel!

W

For your info - you have to set up 3 collection specs using ICP Accel (X), ICP Accel (y) and ICP Accel (Z).

This will work with Enpac or Datapac 1500. Refer to help menu in Emonitor.

W

hello

thank you very much about your response